What Realme UI changed
Realme UI 5 closed the dialer and Emergency Call loopholes that older guides relied on. Those sequences now dead-end at the FRP screen, which is why search results for them keep failing.
The chipset route is unaffected. BROM sits below the OS, so a Realme UI security patch cannot close it — that is a firmware-level change, not an app-level one.
Check your chipset first
Most Realme and Narzo mid-range devices are MediaTek, but not all. Confirm before choosing a transport: FRPB reports the detected vendor, and a MediaTek part will show vendor ID 0E8D when it enumerates in preloader mode.
If FRPB reports a Qualcomm vendor instead, use the EDL procedure rather than the BROM one — they are not interchangeable.
The BROM sequence in practice
Power off, hold both volume keys, connect the cable. FRPB's detector is specifically filtering out Bluetooth and virtual COM endpoints, so a headset on COM3 cannot be mistaken for the phone — you are waiting for a genuine MediaTek port.
Once the Boot ROM answers, FRPB injects the DA payload, reads the partition table and formats the FRP-bearing partitions before rebooting.
If detection never fires
Three causes cover almost every case: a charge-only cable, a USB hub between phone and PC, or a missing VCOM driver. Connect directly to a rear port, use a known data cable, and install the MediaTek driver from the FRPB Driver Center.
If it still does not enumerate, the keys were likely released too early. Keep them held for the full five to ten seconds while the cable is in.
Step-by-step procedure
Follow the sequence below in order. Each step is also published as structured HowTo data, so search results can surface it as a step-by-step list.
- 1Power the Realme device off completely.
- 2Hold Volume Up + Volume Down together.
- 3Connect the USB cable while holding the buttons.
- 4Wait for the MediaTek USB Port to enumerate.
- 5Confirm FRPB reports the BROM transport.
- 6Run FRP Bypass and accept the disclaimer.
- 7Allow the format sequence and reboot to finish.
Safety, legality and when to stop
FRPB is intended strictly for authorised device owners and licensed repair professionals. You must own the device or hold explicit written permission from its owner. Using an FRP bypass tool on hardware you do not own may defeat an anti-theft control and can be illegal in your jurisdiction.
Stop and reassess if the device reports a bootloader state you did not expect, if the model or chipset FRPB detects does not match the handset in front of you, or if the operation halts mid-way. A mismatched firmware package is the single most common cause of a hard brick — abandoning an operation is always cheaper than recovering from one.